- Installation Photo Gallery - ScreenShots - Introduction, Access to configuration page, Configuring the communication ports (Serial & UDP)
- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset - Heading Instrument
- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset - Heading Instrument
$--VHW – Water Speed and Heading Standard: IEC 61162-1, 2000
$--VHW |
x.x |
T |
x.x |
M |
x.x |
N |
x.x |
K |
*hh |
<CR><LF> |
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
Identifier VHW |
True Value |
T |
Magnetic Value |
M |
Speed Value |
N |
Speed Value Km/hr |
K |
Checksum |
Enter End of sentence |
Heading True |
|
Name= type a name Port_No= type the Port Identifier=VHW Ref= Ref_Location= Field_Type=Numeric Field_Location=2 Ratio=1 Offset=0 Status= Status_Location= Unit= Unit_Location= Assign=Value_08
|
|