- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset - Heading Instrument - Enviromental
$--MDA,x.x,I,x.x,B,x.x,C,x.x,C,x.x,x.x,x.x,C,x.x,T,x.x,M,x.x,N,x.x,M*hh<CR><LF>
1 |
$--MDA |
Identifier |
|
2 |
x.x |
Barometric pressure in inches of mercury |
|
3 |
I |
Inches of mercury |
|
4 |
x.x |
Barometric Pressure in Bars |
*for mB (ratio=1000) |
5 |
B |
Bars |
|
6 |
x.x |
Air Temperature |
|
7 |
C |
Air Temperature in C |
|
8 |
x.x |
Water Temperature |
|
9 |
C |
Water Temperature in C |
|
10 |
x.x |
Relative humidity % |
|
11 |
x.x |
Absolute humidity % |
|
12 |
x.x |
Dew point |
|
13 |
C |
Dew point C |
|
14 |
x.x |
Wind direction true |
|
15 |
T |
True |
|
16 |
x.x |
Wind Direction magnetic |
|
17 |
M |
Magnetic |
|
18 |
x.x |
Wind speed knots |
|
19 |
N |
Knots |
|
20 |
x.x |
Wind speed m/sec |
|
21 |
M |
m/sec |
|
22 |
*hh |
Checksum |
|
23 |
<CR><LF> |
Enter |
|
Barometer |
Air Temperature |
Rel Humidity |
Name= type a name Port_No= type the Port Identifier=MDA Ref= Ref_Location= Field_Type=Numeric Field_Location=4 Ratio=1000 Offset=0 Status= Status_Location= Unit= Unit_Location= Assign=Value_09
|
Name= type a name Port_No= type the Port Identifier=MDA Ref= Ref_Location= Field_Type=Numeric Field_Location=6 Ratio=1 Offset=0 Status= Status_Location= Unit= Unit_Location= Assign=Value_11
|
Name= type a name Port_No= type the Port Identifier=MDA Ref= Ref_Location= Field_Type=Numeric Field_Location=10 Ratio=1 Offset=0 Status= Status_Location= Unit= Unit_Location= Assign=Value_12
|
|