|
NM-541 MUX 5-channel NMEA multiplexer with Serial,USB, RS-422
NM-541 MUX-ETH 5-channel NMEA multiplexer with Serial,USB, RS-422, Ethernet Introduction, Operation, Input ports, Output ports, Typical application, Power supply, LED indicators sequence, DIP switch settings, Printed circuit board, Specification, Ethernet interface connection, Device Discovery utility, Configuration, UDP configuration, Downloads |
|
CONFIGURATION OF THE NM-541MUX FOR UDP SOCKETS MULTICAST FUNCTION
After discovering and setting to a fixed IP address as described earlier the following steps must be completed to setup the device to multicast the received NMEA data to UDP sockets.
STEP 1:
Double click on the discovered device in the Digi Discovery Utility to bring up the login menu on an http explorer. Complete the appropriate field and press the Login button
Username: root
Password: nm2003
Double click on the discovered device in the Digi Discovery Utility to bring up the login menu on an http explorer. Complete the appropriate field and press the Login button
Username: root
Password: nm2003
STEP 2:
Click on Serial Ports under Configuration menu as shown below
Click on Serial Ports under Configuration menu as shown below
STEP 3:
Click on Port 1 under Serial Port Configuration menu
Click on Port 1 under Serial Port Configuration menu
STEP 4:
Click Change Profile… to set a new profile
Click Change Profile… to set a new profile
