- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset
CONFIGURING THE (GAUGE1) AS RUDDER INDICATOR
Autopilot Stby indicator, Autopilot Auto indicator, Rudder pump indicator
The min scale, max scale and the name can be adjusted by pressing the <GAUGES> button in the configuration page.
The NMEA sentence related to rudder indicator is the $--RSA
|
$--RSA |
x.x |
A |
x.x |
A |
*hh |
<CR><LF> |
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
|
Identifier RSA |
Stbd or Single Rudder Value |
Status A V |
Port Rudder Value |
Status A V |
Checksum |
Enter End of sentence |
|
Rudder Value |
Rudder Graphic |
Comments about RSA Graphic condition |
|
Name= type a name Port_No= type the Port Identifier=RSA Ref= Ref_Location= Field_Type=Numeric Field_Location=2 Ratio=1 Offset=0 Status= Status_Location= Unit= Unit_Location= Assign=Value_05
|
Name= type a name Port_No= type the port Identifier=VWR Ref= Ref_Location= Field_Type=Numeric Field_Location=2 Ratio=3 Offset=90 Status= Status_Location= Unit= Unit_Location= Assign=Value_06
|
Ratio The ratio in Graphic condition is set to 3 in order to multiply Rudder Value x 3 The divisions on the picture that represents the Graphic rudder are designed every 9 degrees
Offset The offset is set to 90 because the required (0 point) is +90 from 0 of a geometrical xx’ axis |
