- Installation Photo Gallery - ScreenShots - Introduction, Access to configuration page, Configuring the communication ports (Serial & UDP)
- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset - Heading Instrument 

CONFIGURING THE HEADING INDICATOR

Picture
The Heading Indicator  consists of the Digital value part, the graphic presentation.
Available modes are True and Magnetic .
Both digital and graphic using the same value Heading Magnetic (Value_07) and heading True (Value_08) 

The NMEA sentence related to true heading is the $--HDT ,$ --VHW, $-- THS
The NMEA sentences related to magnetic heading are  $--HDM,  $--HDG

True and Magnetic heading are available in a lot of NMEA sentences. So if the above sentences are not available in your data network feel free to decode any sentence with heading data in it 
$--HDT,x.x,T*hh<CR><LF>



$--HDT

x.x

T

*hh

<CR><LF>

1

2

3

4

5

Identifier

HDT

Heading

Value

True

T

Checksum

Enter

End of sentence




Heading True

$--HDT

Name= type a name

Port_No= type the Port

Identifier=HDT

Ref=

Ref_Location=

Field_Type=Numeric

Field_Location=2

Ratio=1

Offset=0

Status=

Status_Location=

Unit=

Unit_Location=

Assign=Value_08


If the boat's gyro installation has a fixed deviation from add it as an offset to correct it