- Installation Photo Gallery - ScreenShots - Introduction, Access to configuration page, Configuring the communication ports (Serial & UDP)
- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset - Heading Instrument
- Setting up Sensors and Conditions - List of Values, presentation of values in the Navigation page - Configuring Relative Wind Sensor
- Configuring True Wind Sensor - Configure GAUGE1 as Rudder - Ratio & Offset - Heading Instrument
$--THS,x.x,Status*hh<CR><LF> Heading True
|
$--THS |
x.x |
A |
*hh |
<CR><LF> |
|
1 |
2 |
3 |
4 |
5 |
|
Identifier THS |
Heading Value |
Status A – Autonomous E – Estimated (dead reckoning) M – Manual input S – Simulator mode V – Data not valid ( or Stby) |
Checksum |
Enter End of sentence |
|
Heading True |
$--THS |
|
Name= type a name Port_No= type the Port Identifier=THS Ref= Ref_Location= Field_Type=Numeric Field_Location=2 Ratio=1 Offset=0 Status= Status_Location= Unit= Unit_Location= Assign=Value_08
|
|
