|
NM-422ETH
NMEA-0183 Multiplier With Ethernet Interface (User Guide) Introduction, Operation, Inputs, Outputs, Power supply, Connections, Connecting Ethernet interface, Led indicators, Configuring as Dual Converter, AutoPilot port, Specifications, troubleshooting, Installing Discovery utility, Using Discovery utility, DHCP Configuration, Manual Configuration, Virtual Port, UDP configuration, Downloads
|
Price 270.00 Euro
On-line orders -15% |
Manual IP configuration (Static IP)
Configuring Network settings manually (recommended) can be done by checking Manually configure network settings radio button. Select for every NM-422ETH a different address in IP address field matching the 192.168.0.X or 192.168.1.X local network standard and leave subnet mask the same (255.255.255.0) for every device. Click Save to continue.
|
|
NM-422ETH will then restart and after a minute it will appear again with no warnings in the window. In the bottom left corner the new IP details appear indicating that NM-422ETH it is manually configured (Static IP). If no new settings appear in window after a minute user should click on the refresh button to research for NM-422ETH devices over local network
Installing Virtual Port Drivers (Windows XP)
Before installing Windows XP driver for the NM-422ETH installer must first check that:
1. NM-422ETH is powered up correctly
2. Ethernet cable is connected
3. Discovery utility is already set up
4. Either fixed IP address (recommended) or DHCP address has been assigned to NM-422ETH
NM-422ETH is configured as a Real-Port (already done in production stage)
1. NM-422ETH is powered up correctly
2. Ethernet cable is connected
3. Discovery utility is already set up
4. Either fixed IP address (recommended) or DHCP address has been assigned to NM-422ETH
NM-422ETH is configured as a Real-Port (already done in production stage)
|
STEP 1:
Connect NM-422ETH power and network cable, open control panel and select Add Hardware |
|
|
STEP 2:
Select Next to continue with the Add Hardware Wizard |
|
